SDM-44040 & SDM-44041 - Stepper Amplifiers for DMC-40x0

  • Manufactured by: Galil Motion Control

Quick Overview

 SDM-44040 4-axis Stepper Drives
 

The SDM-44040 contains four drives for operating two-phase bipolar step motors.The SDM-44040 requires a single 12-30 VDC input.The unit is userconfigurable for 1.4 A, 1.0..

Description

 SDM-44040 4-axis Stepper Drives
 

The SDM-44040 contains four drives for operating two-phase bipolar step motors.The SDM-44040 requires a single 12-30 VDC input.The unit is userconfigurable for 1.4 A, 1.0 A, 0.75 A, or 0.5 A per phase and for full-step, half-step, 1/4 step or 1/16 step.

 

SDM-44140 4-axis Microstep Drives

 

The SDM-44140 contains four microstepping drives for operating twophase bipolar stepper motors.The drives produce 64 microsteps per full step or 256 steps per full cycle which results in 12,800 steps/rev for a standard 200-step motor.The maximum step rate generated by the controller is 6,000,000 microsteps/second.Correct motor sizing calculations are critical to achieve stepper performance at speed.Please contact Galil for assistance. The SDM-44140 drive motors operating up to 3 Amps at 12 to 60 VDC (available voltage at motor is 10% less).There are four software-selectable current setting: 0.5 A, 1 A, 2 A and 3 A.Plus, a selectable low-current mode reduces the current by 75% when the motor is not in motion.No external heatsink is required.

 


Datasheet (PDF file - 0.36 Meg)

 

Ask a question about the SDM-44040 & SDM-44041 - Stepper Amplifiers for DMC-40x0





Manufacturer Informations

Galil Motion Control

    With over 750,000 controllers sold, Galil is a leading manufacturer of motion controllers and PLCs.
    Since introduction of the first microprocessor-based motion controller in 1983, Galil has remained one of the industry’s leading innovators. Located in Rocklin, California, Galil is a privately held company

    Other products